If the light bulb lights, then it is good. Both of the wire contacts should be touching separate metal plates. Hold the bulb by the tip and gently push the 2 wire contacts against the two metal plates located on the bulb tester. To test the light bulbs simply remove the bulb using the bulb remover. If you are unsure if you have locking bases on your light strand, then refer to the light strand manufacturer’s instructions on bulb removal. These require you to unlock the bulb husk from the base in order to remove the bulb. Use our tag explorer to find some records! See All Tags. Note: Some light strands have what is known as a “locking” base or clip.Īll of our records are tagged, based on topic or objects used. Gently rotate the bulb remover to the left and right until the bulb is loose enough to pull out with your fingers. To remove bulbs using the Bulb Remover, simply insert the metal plate between the bulb husk and the bulb base. If the LED does not flash, check the batteries are correctly installed, clean, and in good condition. If the LED flashes on then off the batteries are okay. Replace the batter cover and test the batteries by holding down the push button for 4 seconds. To use the light tester, remove the battery cover and insert the 2 batteries into the battery compartment. Instructions on use and care of the Christmas light tester are included. The Christmas light tester comes with 2 “LR44” watch batteries. The light tester has a built in bulb remover to remove bulbs from the light set easily. The Christmas light tester will test bulbs, fuses, and the light strand. With a push of a button you can locate your Christmas light string problem. Best Answer: Christmas Light Tester Item Number: TD24 28540 This Christmas Light Tester will allow you to easily find any burned out bulbs on your Christmas lights.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |